Nussbaum SMART LIFT 2.30 SL Manual Del Usuario página 108

Made
in
Germany
Bild. B) Drive in the middle of the lift.
Alternative lifting position
Swivel in the carrier arm and pull out properly to the de-
sired length.
The adjustable receiving plates must be placed at the
points specified by the vehicle manufacturer.
108
Version with MINI-MAX lifting arms
Figure 1: Position carrier plate below the fixture points approved by the
vehicle manufacturer
Figure 2: If required, place the carrier plate by pushing the lever at the
fixture points
Ensure that the ratchet is securely locked
!
into the intended position. Otherwise the
"MINI-MAX" can sink to its lowest position.
Figure 3: To release the fixture plate, the rear lever must be pushed.
• The lifting arm block must be ratcheted in after the fix-
ture point has been reached.
• After each set down of the vehicle, check the lifting arm
positions below the fixture points again and adjust as
required.
• Check that there are no people or objects in the hazard-
ous area of the lift.
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL_V4.4_DE-EN-FR-ES-IT