Selco RC10 Instrucciones De Uso página 25

10.0 SETTING THE MMA WELDING
PARAMETERS
Select the type of electrode required.
Select the diameter of the electrode.
The display proposes the optimum welding parameters based on
the choice made. Press the T7 keys to make any corrections to
the welding current set. Change the welding parameters where
necessary, using the T1 Key.
10.1 Setting the parameters for MMA welding in graphics mode
By using the graphics mode you can have better immediacy and
simplicity of use in the control of the welding parameters. To
activate the graphics mode, just press the F1 key from the page
displaying e parameters. The graphics mode stays active even
when the machine is turned off. To return to the text mode, press
the F1 key again.
The graph shows the qua-
lity trend of the welding
current.
The status bar contains the
indicator for output voltage
presence and the readings
of the welding voltage and
current.
By pressing the DATA CHANGE key, it is possible to change the
welding parameters not shown. The status bar is replaced by the
data setting line.
In the graph, the welding parameters to
be changed are clearly shown.
The entry line contains the name and numerical
value of the parameter to be modified. With the
T6 keys, the parameter required is selected; set
the new value and confirm it with the ENTER key.
At the end of the operation, the status bar will
appear again.
The first line shows the type of dia-
meter of the electrode selected. It
is possible to modify it by pressing
the ESC key and making a new
selection according to the method
described above.
This is the welding current set,
which can be changed with the
T7 keys.
25