Overview Of Adjustment Parameters In Mymodes; Turning Bluetooth On The Prosthesis On/Off; Switching Bluetooth Off/On Using The Cockpit App - Ottobock C-Leg 3C98-3 Instrucciones De Uso

Parameter
Volume

8.2.3 Overview of adjustment parameters in MyModes

The parameters in the MyModes describe the static behaviour of the prosthesis for a specific
motion pattern such as cross-country skiing. Damping behaviour is not automatically controlled
and adjusted in MyModes.
The following parameters can be modified in MyModes:
Parameter
Gain
Volume

8.3 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see Page 71).

8.3.1 Switching Bluetooth off/on using the cockpit app

Switching off Bluetooth
1) When the component is connected, tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Functions".
3) Tap the entry "Deactivate Bluetooth".
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Rotate the component or connect/disconnect the battery charger.
Adjustment Setting
software range, app
range
0 to 4 0 to 4
Adjustment Setting
software range, app
range
0 to 100 +/- 10
0–4 0–4
Meaning
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals are still generated if errors
occur.
Meaning
Value for speed at which flexion resist­
ance increases as the knee angle
increases
Volume of beep signal for confirma­
tion tones (e.g. when checking the
charge level, switching MyModes).
The "0" setting deactivates the aud­
ible feedback signals. However, warn­
ing signals are still generated if errors
occur.
71