Status Signals; Directives And Manufacturer's Declaration; Electromagnetic Environment - Ottobock C-Leg 3C98-3 Instrucciones De Uso

16.2.4 Status signals

Battery charger is connected
LED on LED on bat­
power tery charger
supply
Battery charger disconnected
Beep Vibration
signal signal
1 x short 1 x short
3 x short –
– –
Battery charge level
Battery char­
ger
Battery is being charged, battery charge level is less than 50%
Battery is being charged, battery charge level is over 50%
Battery is fully charged (or connection with product is interrupted).
Take note of the confirmation signal for differentiation.
When the battery charger is connected or disconnected, a self-test is conduc­
ted and confirmed by a beep and vibration signal.
The battery is fully charged if this signal is heard.
If no signal is emitted, the connection to the product is interrupted.

16.3 Directives and manufacturer's declaration

16.3.1 Electromagnetic environment

This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
The customer or user of the product must ensure that it is operated in such an environment.
Observe the safety notices in the section "Information on proximity to certain areas" (see
Page 55).
The following tables outline the test levels of the tests to be carried out. The higher value applies if
there is a difference between the operating environments listed in the tables below.
84
Event
Power supply and battery charger operational
Event
Self-test completed successfully. Product is operational.
Maintenance note
Conduct the self-test again by connecting/disconnecting the battery
charger. If the beep signal sounds again, visit your O&P professional
soon. If necessary, he or she will forward the product to an authorised
Ottobock Service Center.
The product can be used without restrictions. However, vibration signals
may not be generated.
Conduct the self-test again by connecting/disconnecting the battery
charger. If no beep and/or vibration signal is emitted after connect­
ing/disconnecting the battery charger again, the product must be
inspected by the O&P professional.