Yamaha WaveRunner FX140 Manual De Servicio página 106

Ocultar thumbs Ver también para WaveRunner FX140:
Tabla de contenido

Publicidad

INSP
ADJ
CONTROL SYSTEM
2. Adjust:
• QSTS cable
Adjustment steps:
• Set the control grip in the neutral position.
• Loosen the locknut 1.
• Remove the nut 2 and pivot pin 3.
• Set the jet thrust nozzle in the center
position.
• Turn the cable joint 4 for adjusting.
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
• Connect the cable joint 4 and pivot pin
3 and tighten the nut 2.
Nut:
3.8 N • m (0.38 kgf • m, 2.7 ft • lb)
• Tighten the locknut 1.
Locknut:
3 N • m (0.3 kgf • m, 2.2 ft • lb)
NOTE:
If the QSTS cable cannot be properly adjusted
by the cable joint at the QSTS converter end,
adjust the cable joint at the jet pump end so
that the same lengths are obtained. Refer to
"REMOTE CONTROL CABLES AND SPEED
SENSOR LEAD" in Chapter 8.
3-6
Length a is increased.
Length b is increased.
E

Publicidad

Tabla de contenido
loading

Tabla de contenido