Scanning In Hand-Held Mode; Setting Bar Code Format Options - Medtronic ACT Plus Manual Del Usuario

Scanning in Hand-Held Mode

1. Connect the scanner cable to the bar code scanner and the ACT Plus
instrument. The scanner will beep when power is on.
2. Aim the scanner at the bar code and press the trigger.
3. Be sure that the red line from the scanner goes across the entire bar code.
When the scanner has successfully decoded the bar code, the scanner will beep,
and the information will be entered into the ACT Plus

Setting Bar Code Format Options

1. Scan the following bar codes in sequence. The scanner will beep when it
successfully reads a setup bar code. If you make an error, start over.
2. Scan the "Reset Default Values" bar code (Figure 37).
3. Scan the "IBM PC/AT & IBM PC compatibles" bar code (Figure 38) to set
communication to a PC.
Figure 38. IBM PC/AT and IBM PC Compatibles bar code
4. Scan the "Low Volume" bar code (Figure 39) to set the volume mode to Low.
5. Scan the "Interleave 2 of 5 to Any Length" bar code (Figure 40).
70 English
Figure 36. Correct scan location
Figure 37. Reset Default Values bar code
Figure 39. Low Volume bar code
®
instrument.
®
ACT Plus Operator's Manual
®