Procedure For Setting The Defaults - Medtronic ACT Plus Manual Del Usuario

Procedure for setting the defaults:

1. To ensure that the scanner is reset, first scan the Set All Defaults bar code.
2. Scan the "Low Volume" bar code, unless a different volume is desired.
3. Scan the "Transmit Code ID" barcode to allow the barcode scanner to
transmit the ID of Barcode format along with the data of the barcode that was
just scanned.
4. Scan the "Enable UCC/EAN-128" bar code. The cartridges and controls use
this format.
5. Scan the "Scan Prefix" bar code, then scan the following numbers: 1, 0, 0, 2.
®
ACT Plus Operator's Manual
Figure 18. Set All Defaults bar code
Figure 19. Low Volume bar code
Figure 20. Transmit Code ID
Figure 21. Enable UCC/EAN-128 bar code
Figure 22. Scan Prefix bar code
Figure 23. 1 bar code
English 65