Descargar Imprimir esta página

Important Safety Instructions - Sears Kenmore 385.16622 Manual De Instrucciones

Publicidad

iMPORTANT
SAFETY
INSTRUCTIONS
When using an electrical appliance, basic safety precautions should always be followed, including the following:
Read all instructions before using this appliance..
DANGER-
To reduce the risk of electric shock:
1.. An appliance should never be left unattended when plugged in, Always unplug this sewing machine from the electric
outlet immediately after using and before cleaning,
2,
Always unplug before replacing a Serger bulb, Replace bulb with same type rated !5 Watts.
WARNING-To,odooe , .o.sk
e,eo,.c..ock
o, ni. j po,.oo.:
1,
Do not allow to be used as a toy, Close attention is necessary when this Serger is used by or near children.
2.
Use this appliance only for its intended use as described in this owner's manual. Use only attachments
recommended by the manufacturer as contained in this owner's manual.
3.
Never operate this Serger if it has a damaged cord or plug, if it is not working properly, if it has been
dropped or damaged, or dropped into water.,
Return this Serger to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment.
4.
Never operate the appliance with any air opening blocked, Keep ventilation openings of this Serger and foot controller
free from accumulation of lint, dust and loose cloth.
5.
Never drop or insert any object into any opening,
6,, Do not use outdoors°
7., Do not operate where aerosol (spray) products are being used or where oxygen is being administered_
8_ To disconnect, turn a!f controls to the off ("O") position, then remove plug from outlet_
9,. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord,
I0o Keep fingers away from all moving parts. Special care is required around the sewing machine needle.
11. Always use the proper needle plate. The wrong plate can cause the needle to break,
t2. Do not use bent needles.
13_ Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
14o Switch this Serger off ("O") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin, changing the presser foot, and the like,.
15. Always unplug this Serger from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual.
SAVE THESE iNSTRUCTIONS
NOTE: Serger design and specifications are subject to change without prior notice,

Publicidad

loading