Adjustment Of Needle Plate Setting Knob; (Changing To Standard Serging Or Rolled Hemming); Standard Serging; Rolled Hemming - Sears Kenmore 385.16622 Manual De Instrucciones

Adjustment of needle plate setting knob
(Changing to standard serging or rolled
hemming)
C) Chaining finger
(_ Guide line
_) Cutting width adjusting dial
O Needle plate setting knob
Upper knife
The needle plate setting knob is connected to the chaining
finger.
The chaining finger slides from beside to below the needle
position when you move the needle plate setting knob from
"S" to "R"..
El] Turn off the power switch and unplug the machine..
[] Open the looper and side covers.
Disengage the upper knife (refer to page 16).
Push the cutting width adjusting dial to right as far as it
wilt go, then move the needle plate setting knob to
S (for Standard Serging) or R (for Rolled Hemming)°
Gently release the cutting width adjusting dial to the left..
[] Close the looper and side covers.
%[]@%%
® Standard serging
(_) Chaining finger
Needle plate setting knob
(_) Guide line S
The chaining finger C) is located beside the needle plate
as shown in diagram @ for guiding the flat edge of the
fabric for overlock sewing.
(_) Rolled hemming
(!) Chaining finger
(_) Needle plate setting knob
(_) Guide line R
The edge of the fabric will be rolled hemming, picot edging,
or narrow hemming, when the chaining finger C) is pulled
out toward you to the "R" position (_) under the needle plate
as shown in diagram (_..
J
2O
J