Sartorius Gold & Carat II Line GL822I-2 Serie Instrucciones De Manejo página 18

System Settings
Parameter Setting values
ZER./TAR. W/O STB.
W/ STAB.*
AUTOZER. ON*
OFF
WT.UNIT GRAMS*, KILOGR.,
CARATS,
POUNDS,
OUNCES, TROY.
OZ., HKTAEL,
SNGTAEL,
TWNTAEL,
GRAINS,
PENYWT.,
MILLIGR., PTS./LB,
CHNTAEL.,
MOMMES, AUSTR.
CT, TOLA, BAHT,
MESGHAL,
NEWTON
DISP.DIG. ALL**
DIVIS. 1***
MINUS 1
MINUS 2
CAL./ADJ. EXT.CAL.
E.CAL.USR.
INT.CAL.*
CAL.SEQ. ADJUST*
CAL.-ADJ.
ON Z/T ON*
OFF
* Factory setting
** Deviating factory setting: Only for models with x= SVN
*** Factory setting for gold and carat only
18 Operating Instructions Gold&Carat II Line
Explanation
If the button is pressed: The function of the [Zero] or [Tare] button is
executed immediately.
The function of the [Zero] or [Tare] button is only executed after stability is
achieved.
Activates automatic zeroing. The display is automatically set to zero in case of
a deviation of 0 less than (X).
Deactivates automatic zeroing. Zeroing must be triggered with the [Zero]
button.
— The device displays the weight in the selected unit.
— The availability of units depends on national legislation and is therefore
country-specific.
"Show all decimal places": All decimal places are shown in the display. The
setting change is not available on conformity-assessed devices.
"Last digit scale interval 1": The last digit always shows scale interval 1.
"Last decimal place off": The last decimal place is switched off.
"Last two digits off": The last two digits are switched off.
The [Adjust] button starts an external calibration and adjustment process
with the preset calibration weight.
The [Adjust] button starts an external calibration and adjustment process
with the user-defined calibration weight value.
The [Adjust] button starts an internal calibration and adjustment process.
The adjustment starts automatically after the calibration.
The adjustment must be started or exited manually after calibration with the
[Confirm] button.
Activates the initial taring | zeroing. The device is tared or zeroed after it is
switched on.
Deactivates the initial taring | zeroing: After it is switched on, the device shows
the same value as before it was last switched off.