Publicidad
Idiomas disponibles
Idiomas disponibles
CHANGING THE LAMP
To carry out this operation, proceed as follows.
1) Undo the screws and remove the lamp cover (A).
2) Extract and replace the lamp (B).
Caution - Warning
During the procedure, take care not to touch the lamp directly; wear protective gloves if necessary.
3) Replace the lamp cover (A) and retighten the screws when the operation is complete.
CHANGING THE IGNITION PLUG
To carry out this operation, proceed as follows.
1) Undo the screws to remove the side panel (A).
2) Open the tangs (B) and remove the guard (C).
3) Undo the nuts (D) to remove the ignition plug unit (E).
4) Replace the guard and close the tangs when done.
GB
APPLIANCE DECOMMISSIONING, DEMOLITION AND DISPOSAL
When decommissioning the appliance, a series of procedures must be carried out to ensure
that the appliance and its components are not a hindrance and are not easily accessible.
To ensure that the appliance cannot constitute hazards for people or the environment, all
energy sources (electricity, etc.) must be disconnected and rendered unusable, and any liquids
present must be drained (lubricants, fl uids, etc.).
Place the appliance in a suitable area which is not easily accessible, with barriers to prevent
anyone from accessing it.
When scrapping, sort all components by chemical characteristics and dispose of them separa-
tely in accordance with the relevant legal requirements.
Important
Do not dump non-biodegradable products, lubricating oils, and non-metallic components (rub-
ber, PVC, resins, etc.) in the environment. Dispose of them in compliance with the relevant laws.
3338970_GB_inst
A
A
E
C
- 16 -
B
B
D
D
ENGLISH
Publicidad
