Grundfos CRE Manual De Instrucciones página 8

4.1 Transporting the product
WARNING
Falling objects
Death or serious personal injury
‐
Secure the product during transport to
prevent it from tilting or falling down.
CAUTION
Back injury
Minor or moderate personal injury
‐
Use lifting equipment.
CAUTION
Crushing of feet
Minor or moderate personal injury
‐
Wear safety shoes when moving the
product.
4.3 Lifting the product
WARNING
Falling objects
Death or serious personal injury
‐
Use lifting equipment rated for the
weight of the product.
‐
Attach lifting equipment to the motor
eyebolts to lift the entire product.
‐
Wear personal protective equipment.
‐
Keep a safe distance to the product
during lifting operations.
‐
Follow the lifting instructions for the
product.
WARNING
Back injury
Death or serious personal injury
‐
Use lifting equipment and follow local
regulations when lifting the product.
Observe local regulations concerning limits
for manual lifting or handling. Calculate the
total weight of the pump with motor by
adding the weights stated on the pump
and motor nameplates.
Do not lift the product by the terminal box.
Note that typically the center of gravity of
the pump is close to the motor.
8
For lifting instructions, see the related
installation and operating instructions for
the pump.
5.1 Installing the product outdoors or in areas
with high humidity
WARNING
Fire hazard
Death or serious personal injury
‐
In high humidity environments where
condensation can occur, connect the
product permanently to the mains
supply and activate the standstill
heating function.
To maintain the cURus mark, additional
requirements apply to the equipment. See
the appendix concerning installation in the
USA and Canada.
Do not expose the product to UV radiation.
If you install the product outdoors or in areas with a
high humidity, take the following action to avoid
condensation on the electronic components.
• Provide the product with a suitable cover.
The cover must be large enough to ensure that
the product is not exposed to direct sunlight, UV
radiation, rain or snow. Grundfos does not supply
covers.
When fitting a cover to the product,
observe the instructions for adequate
cooling.
• Open the drain holes in the product.
When you open the drain hole, the
enclosure class of the motor will be
lower than standard.
• Connect the product permanently to the mains
supply. In areas with a high humidity, activate the
built-in standstill heating function.