CUBO & CUBOMATIC
OPERATING MANUAL
5.
The vehicle working functions include those described in the following paragraph "PREPARING FOR WORKING IN MANUAL
MODE".
11 DRIVING POSITION
In automatic mode (AUTO), the vehicle follows the operator straight behind him.
WARNING
–Before starting operating, it is important to identify the route to be followed by paying attention to the
flow of other means present in the surroundings, so that the operator always works on the sidewalks and on the
protected side. Be careful when going up anddown from sidewalks, to avoid machine overturning, this can be done only
in areas where the sidewalk is designed to allow entry and exit via ramp access. The machine must never go down from
the sidewalk and must never take steps in points not provided.
WARNING
– In the event that operator has to overcome obstacles in ascent or descent (eg kerbs of sidewalks),
ALWAYS use the vehicle in manual mode (MAN).
To prevent the vehicle from overturning, this operation can only take place in the areas where the sidewalk is set up to
allow the ascent and descent via the access ramp. Never step off the sidewalk at other unforeseen points or mounting
kerbs with the vehicle.
WARNING
– The machine in automatic driving mode (AUTO) DOES NOT DETECT changes in height or depth (eg
kerbs, holes, slopes).
Obstacles that are too low or too high may not be detected.
WARNING
– In automatic mode (AUTO), the operator must always keep a safe distance from obstacles, taking into
account the dimensions of the vehicle that follows him.
WARNING
– In automatic mode (AUTO) the operator must always keep a safe distance from the movement area of the
steering handle.
WARNING
–The vehicle must not be used by persons (including children) with limited physical, sensory or mental
capabilities or without experience and / or skills, unless such persons are accompanied and supervised by a person
responsible for their safety or if they have received precise instructions for vehicle use. The operator is solely
responsible during the use of the vehicle, even during the use of the system in automatic mode (AUTO) and TSM SRL
excludes any liability for damage caused to things or persons from improper use of the vehicle.
12 START & STOP
Start
Turn the ignition key in position "ON";
Stop
CUBO/CUBOMATIC SANISPRAY
Switch the chemical off and spray only water for a few minutes.
WARNING
–This operation is of fundamental importance to avoid any fouling of the chemical inside the pump, which
can lead to damage to the pump itself.
CUBO/CUBOMATIC 180
Empty hoppers.
Turn the ignition key to position "OFF";
Remove the key;
Sidewalk
Road