Hella Gutmann mega macs PC SE Manual De Instrucciones página 186

11. | Working with the mega macs PC SE
ð The device automatically activates all ECUs.
ð Deactivate all ECUs with
ð Activate all ECUs with
9. Activate/deactivate the requested ECUs.
10. Start the global check with trouble code reading with
ð Communication to vehicle is being established.
ð Activated ECUs are read out. This may take a few minutes.
ð The number of trouble codes in the prevailing ECU memory is indicated.
ð You can call up a print preview with a list of the individual trouble codes for the respective ECU with
ð You can close the print preview with a list of the individual trouble codes for the respective ECU with
11. Call up the required trouble codes under Faults in the respective ECU memory with
ð The device indicates all trouble codes and repair tips.
11.5.2.4. Global Check, Trouble Code Clearing
Here you can clear all the trouble codes stored in the ECUs.
NOTICE
The stored trouble codes cannot be retrieved any more after global check with trouble code deletion. There-
fore, it is recommended to perform the global check with trouble code reading first.
Proceed as follows to perform the global check with trouble code deletion:
1. Perform steps 1 to 10 as described in section Global Check, Reading Trouble Codes [} 184].
NOTICE
Clearing all trouble codes in all vehicle systems is possible only if all systems can be read out with the same
OBD plug.
2. Delete all trouble codes in the bottom toolbar with
3. Regard the window with information and instructions.
4. Confirm the window with infos and instructions with
5. Observe the information window.
6. Confirm the info window with
ð All saved trouble codes will be deleted.
186
.
.
.
.
.
.
Hella Gutmann
.
.
.
mega macs PC SE