Publicidad
Idiomas disponibles
Idiomas disponibles
EN
5.1. Start and stop a charging session
1.
Start charging:
•
Fully unwind the charging cable from around the charging station.
•
Remove the cap from the charging cable plug, then connect the charging cable to your vehicle.
•
If you use a charge card or key fob, hold it in front of the reader on the charging station to start
charging.*
2.
Your vehicle is charging.
3.
Stop charging:
•
If you use a charge card or key fob **, hold it in front of the reader on the charging station to stop
charging.*
•
Disconnect the charging cable from your vehicle.
•
Install the cap on the charging cable plug, then wind the charging cable around the charging station.
Make sure that the plug does not touch the ground when stowed.
* When the charging station is configured to only accept charge cards or key fobs.
** You must use the same charge card or key fob that you used to start the charging session.
5.2. Status indication
LED indicator
1. State of the power supply to the charging
station.
2. Charging station state.
3. Authentication state.
4. EV state.
Note
Some features and status indications are not available on all models.
36
5. All LEDs on.
6. All LEDs pulsing left to right.
7. Each LED on then off in sequence from left to right, at the
normal speed.
8. Each LED on then off in sequence from left to right, at a slower
speed.
9. Single LED on.
10. Single LED on, blinking off two times.
5. User instructions
LED states
Publicidad
