Nilfisk Advance RS 1300 Instrucciones De Uso página 32

ENGLISH INSTRUCTIONS FOR USE
• Dust control system tank water level
relevant indicator (12, Fig. H):
– main tank and sub-tank are full
– main tank is empty and sub-tank is full
– main tank and sub-tank are empty. In this
condition, the dust control system and high-
pressure washing system turn off after about 5
seconds.
!
– the level sensors are faulty or exchanged.
• Machine operation mode
(11, Fig. H):
– transport mode
• Total kilometers travelled
relevant symbol (9).
WARNING!
If the symbol
the key appears on the display, it
means that the maintenance interval
has expired. Proceed as shown in the
relevant chapter.
WARNING!
If the symbol shown is not the specifi ed
one but the warning symbol
appears, it means that some alarms are
stored in the B_BOX. Check the B_BOX
(as shown in the relevant paragraph)
and send the stored alarm codes to a
Advance Service Center to reset the
alarms.
10 33018312(3)2010-01
with the
with the relevant indicator
(10, Fig. H) with the
is not shown, but
3. Working mode visualization
When the engine is running, if the machine is set to
working mode with the brooms turned on (see the
procedure in the relevant paragraph), the display (17, Fig.
D) shows the working mode (28, Fig. H) which contains the
following parameters. Only the parameters different from
transport mode are shown.
• Engine speed : 4-digit number (23, Fig. H) with the
following symbol
CAUTION!
If the engine speed sensor is faulty, upon
start-up the display shows the error
message "SYSCODE.07" (see Alarm
Description paragraph).
To repair the fault, contact a Advance
Service Center.
• Machine operation mode
(24, Fig. H):
– working mode
• Engine operation hours
symbol (27).
WARNING!
If the symbol
the key
means that the maintenance interval
has expired. Proceed as shown in the
relevant chapter.
WARNING!
If the symbol shown is not the specifi ed
one
appears, it means that some alarms are
stored in the B_BOX. Check the B_BOX
(as shown in the relevant paragraph)
and send the stored alarm codes to a
Advance Service Center to reset the
alarms.
4. Alarm visualization
When the engine is running, in case of machine
malfunctions, the alarms will be shown on the display (17,
Fig. D).
These alarms are classifi ed as instrument inner alarms
(2, Fig. D) displayed in (7, Fig. I) and AIA control board
transmission line inner alarms shown in (8). To fully
understand the alarms, see the Alarm Description
paragraph.
RS 1300
ENG
(25).
rpm
with the relevant indicator
(26, Fig. H) with the relevant
is not shown, but
appears on the display, it
but the warning symbol