Scrapping - Nilfisk Advance RS 1300 Instrucciones De Uso

ENGLISH
Problem
3RD BROOM ARM
The 3rd broom arm swings.
The 3rd broom arm does not shift
sideways.
The 3rd broom arm does not lift/lower.
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Brooms
– Engine oil
– Hydraulic system oil
– Hydraulic system oil fi lters
– Plastic components
– Electrical and electronic components
NOTE
Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
64
INSTRUCTIONS FOR USE
The tensioning springs are not properly adjusted.
The end-of-stroke sensors are not properly adjusted.
The safety pin is broken.
The microswitch is damaged or the operator is not on the driver's seat.
The microprocessor electronic board is damaged.
The engine speed sensor is not properly installed on the microprocessor electronic board.
The electronic board power supply relay is damaged.
The sensor electronic board is damaged or one of the sensors (1 and 2) is shortcircuited or always
reading.
Lack of tension in the solenoid valve.
The distributor is stuck.
The cylinder gaskets are worn.
The switch is off.
The main fuse is open.
There is an open in the left/right shifting push-buttons.
The relay is burned.
The solenoid valves are burned.
The distributor is stuck.
The cylinder gaskets are worn.
The main fuse is open.
There is an open in the lowering push-button.
There is an open in the lifting push-button.
The relay on the sensor electronic board is damaged.
The solenoid valve is burned.
33018312(3)2010-01
Possible cause
RS 1300