ENGLISH
HYDRAULIC SYSTEM FILTER CHECK/REPLACEMENT
1.
Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
2.
Engage the parking brake (13, Fig. E).
3.
Remove the driver's seat panel (2, Fig. AG) by unscrewing the 4 mounting screws (3).
4.
Check that the clogging indicator (4, Fig. AG) is in the green area (5) at the centre mark.
5.
If the clogging indicator (4, Fig. AG) is in the red area (6) at the centre line the fi lter element (1) is to be replaced.
6.
Remove the element (1) with a suitable tool and pay attention to oil leakages.
7.
Replace the fi lter element with an original spare part.
WARNING!
The oil and fi lters should be disposed of properly according to the environmental laws in force.
8.
Install the driver's seat panel (2).
BATTERY FLUID LEVEL CHECK
WARNING!
Protect body parts (eyes, hair, hands, etc.) properly, when performing battery check and cleaning procedures.
1.
Engage the parking brake (13, Fig. E).
2.
Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
3.
To disconnect the battery (34, Fig. F), turn the key of the release device (47) and then remove it.
4.
Open the left side upper and lower doors (9 and 11, Fig. G) by disengaging the fasteners (10 and 12) with the supplied key.
5.
Check the color of the hygrometer (50, Fig. F); if it is green the battery is ok, if is red:
•
The battery must be refi lled with distilled water
•
The battery must be charged.
If the color of the hygrometer (50, Fig. F) is still red, the battery must be replaced.
6.
If necessary, clean the battery.
7.
Check the battery terminals for oxidation.
8.
Close the left side upper and lower doors (11 and 9, Fig. G) by engaging the fasteners (10 and 12) with the supplied key.
BRAKE FLUID LEVEL CHECK
1.
Engage the parking brake (13, Fig. E).
2.
Turn the ignition key (24, Fig. D) to OFF position and remove it.
3.
Check the brake system fl uid level in the tank (1, Fig. AB). The level must be at 0.4 in (1 cm) from the tank fi ller neck. If
necessary, top up using the same type of brake fl uid that is in the line.
Type of fl uid used: DOT4.
REVERSE GEAR BUZZER SENSOR CHECK
1.
Check that, when the machine moves in reverse, the relevant buzzer sounds.
If necessary, perform the adjustment according to the instructions in the Service Manual.
TIRE PRESSURE CHECK
1.
Engage the parking brake (13, Fig. E).
2.
Turn off the engine, by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, then remove it.
3.
The tire pressure should be as follows:
•
Front tires:
72.5 psi (5.0 Bar)
•
Rear tires:
72.5 psi (5.0 Bar)
42
INSTRUCTIONS FOR USE
33018312(3)2010-01
RS 1300