COMPANION 27824 Manual De Instrucciones página 24

Tabla de contenido

Publicidad

2
_To
install bagger components
to tractor
o
1.
Discharge
Chute
2.
3/8 Nut
3.
Flat Washer
3/_
_'_-"
4
1. Support Bracket
2.
Clevis Pin 10x 17mm
3.
Retainer Spring
4.
Clevis Pin 10x50mm
5.
10,3ram
(13/32")
flat
washer
5
3
Removedischargechutefromrearoftractor. U nhookthe
two (2) strapsand pultchuteout and away from tractor.
Remove the two (2) 3/8 nuts and flat washersfrom the
boltsat the tractorbackplate.
Install the two upper support brackets through the back
plate and to the chassis, install the clevis pin 10x17mm
and secure with retainer spring.
Assemble
both support brackets to the outside of the
baggger support tube install the clevis pin 10x50mm and
secure with retainer spring.
1.
2.
3.
3/8 Lock nut
Flat Washer
Support Tube
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
1. Hook
2.
Discharge Chute
3.
Back plate slot
3
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate, This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24

Publicidad

Tabla de contenido
loading

Tabla de contenido