Tabla de contenido
Publicidad
2
1.
Front bagger tube
2.
Lower bagger tube
3.
1/4x 50,8mm Carriage
Bolts
4.
1/4 Lock nut
5----.... i
2
._
1.
Front bagger tube
1_
_q
2.
1/4 x 50,8mm Carriage
Bolts
4
3.
1/4 Lock nut
4.
Vinyl Binding
5.
Dump handle tube
6MM (1/4") - 9MM (3/8")
6.
Clevis pin
7.
Retainer spring
8. Cap
1
2
3
1. Top Surfaces Even
2,
Horizontal Adjustment Bracket
3.
Vertical Adjustment Bracket
To Assemble
Bagger
NOTE:
For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
gether.
•
Holes in front ba_]ger tube are at an angle. Place front
bagger tube against lower bagger tube and check for
proper hole alignment before assembling baits.
Assemble front and lower bagger tubes using four (4)
1/4 x 50,8ram carriage bolts and lock nuts supplied.
Tighten securely.
•
Slide front and lower bagger tube assembly into the bag-
ger assemby,
•
Assemble front and upper bagger tubes using four (4)
1/4 x 50,8mm carraige bolts and lock nuts supplied.
Tighten securely.
•
Slip all the vinyl bindings over the bagger tubes
•
Slide the bagger dump handle through the hole in the
bagger top, install the clevis pin and secure with retainer
spring.
•
Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
clogged.
Bagger
adjustment
For proper bag function and appearance, it may be neces-
sary to adjust the bagger assembly, There should be 6ram
(1/4")ogmm (3/8") gapbetween the bagger top and fender and
the bagger top surface should be even with the top surface
of the fender. To adjust bagger position:
Horizontal adjustment
Slightly loosenthe nutssecuringthe baggerRH and LH
horizontal a d ustmentbrackets,Loosenonlyenoughso
the bracketskeep their poslion, but a low them to be
moved.
Move the brackets the amount forward or backward you
wish the bag assembly to move. Retighten the nuts se-
curely.
Vertical
adjustment
Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, but allow them to be moved.
Move the brackets the a'nount up or down you wish the
bag assembly to move. 'tetighten the nuts securely.
Reinstall the bagger as_,embly and check the bagger to
fender fit. If necessary, repeat the procedure until proper
fit is attained.
To convert to bagging, mulching or discharge
See "Section 5" of this manual.
25
Publicidad
Tabla de contenido
