Troubleshooting; Problem / Troubleshooting/Solution / Advice - Bezzera ARCADIA DE BREWING PROFILE Manual De Instrucciones

BEZZERA ARCADIA BREWING PROFILE
MOD.

Problem / Troubleshooting/Solution / Advice

7 - TROUBLESHOOTING

Problem
No steam output from the wand The tip of the steam wand is
Leaks from filter holder
Difficulty in inserting the filter
holder on the group head
Incorrect position of the fil-
ter holder once inserted in the
group
The flow of coffee is scarce
Troubleshooting/
Solution
clogged; unclog it with needle.
This problem is caused by the
way the tip is put into the milk.
Possible causes:
1 – The group head gasket is
worn or encrusted.
2 – The filter holder is incor-
rectly inserted in the group.
The problem can be caused by
an excessive dose of coffee in
the filter holder.
Once inserted on the group, the
handle of the filter holder has
shifted to the right. The group
head gasket is worn.
The coffee is dispensed drop by
drop, the output time is too long
and the quality of it is not good,
the cream is dark.
Possible causes:
1 - The coffee is ground too
finely.
2 - The coffee has been pressed
too firmly in the filter holder.
3 - The dose in the filter holder
is excessive.
4 - The group shower head is
clogged.
5 - The filter holder filter basket
is clogged.
6 - The pressure supplied by the
pump is low (< 9 bar – 0.9
MPa) or does not work.
58
Advice
Clean the steam tip after each
use.
Clean it using the brush sup-
plied.
Should the problem
again, call a specialised techni-
cian
Decrease the quantity of coffee
in the filter holder.
Call a specialised technician to
replace the group head gasket.
In cases 1-2-3, the problem
can be solved by adjusting the
grinding and/or dosing.
In cases 4-6, contact a techni-
cian.
In case 5, clean or replace the
filter.
occur