Exchanging Components Of The Cover Plate; Cleaning - FIOR & GENTZ NEURO MATIC Manual De Instrucciones

14.2 Exchanging Components of the Cover Plate

3
If one component of the cover plate wears out, it has to be exchanged
for a new one. To assemble the cover plate again, proceed as follows
(fig. 28):
6
7
1 2
1 Place the sliding washer (1) onto the lever (2).
2 Slide the lever into the hole in the cover plate (3).
3 Slide the ball (4) and the pressure spring (5) into the lever.
4 Press the switching pawl (6) onto the lever from behind.
5 Secure the sub-assembly with the retaining washer for shafts (7) on
4
5
the cover plate.

14.3 Cleaning

fig. 28
The system joint must be cleaned when necessary and during regular maintenance. For this purpose, disas-
semble the system joint and clean the soiled system components with a dry cloth.
35