Use Of The Appliance; Put Crockery In; Take Crockery Out; Use Of The Cover - Hupfer BDC/50-50 Manual De Instrucciones

Coolstapler - basket stacker with cooling by circulating air

Use of the appliance

43.3000.3
• Switch on the appliance with the ON/OFF switch.
The operating indicator integrated in the switch lights up, the appliance is
cooling at maximum power.

Put crockery in

As a rule, the crockery is placed in the baskets before the baskets are put into
the appliance.
The maximum filling height of the baskets must be about 3 to 5 mm below the
upper edge of the basket, otherwise breakage of crockery can occur.
• Place the basket so that it fits exactly on the lower basket and lower it slowly.
Put crockery into baskets located in the appliance:
• Fill the basket more or less evenly so as to avoid tilting of the stacking plat-
form.
The maximum number of stacking baskets which can be used in addition to
the base basket can be found on pages 22 and 29.

Take crockery out

• Take cover off and hang it on the handle on the long side of the appliance.
Do not damage the seal which is then on the outside by collision with other
trolleys or obstacles.
• Remove crockery evenly from each stack to avoid tilting of the stacking
platform.
• Remove empty baskets and stack them in a suitable place.
• Put the cover back on.

Use of the cover

Replace a damaged cover seal without delay.
Even during relatively long temporary storage the covers ensure effective pro-
tection against dust and condensed water.
In operation, the cover placed on the appliance reduces the loss of cooling up-
wards.
A gap between the cover and the top plate of the appliance can already lead
to perceptible cooling losses and thus to an increase in the crockery tempera-
ture.
During removal and loading with crockery the cover should be hung on the
handle on the long side of the appliance.

Automatic operation

The refrigerating system operates fully automatically in the prescribed temper-
ature range. Defrosting always takes place when the appliance is switched off
or disconnected from the power supply. This is normally the case between the
cooling phases. Never use sharp-edged objects to remove increased ice or
bloom.
25