Transport; Taking Out Of Operation; Switch Off The Appliance; Cleaning And Care - Hupfer BDC/50-50 Manual De Instrucciones

Taking out of operation

Cleaning and care

26
Coolstapler - basket stacker with cooling by circulating air

Transport

Observe the safety instructions from page 20 onwards.
• Switch off the appliance at the ON/OFF switch.
• Pull out the mains plug and insert it into the holder provided.
• Release both locking brakes.
• Grip the appliance by the sliding handles and move it to the destination.
• At the destination, lock both locking brakes in order to secure the appliance
against inadvertent movement.
• Insert appliance plug into suitable socket with earth contact
• Switch on the appliance with the ON/OFF switch.

Switch off the appliance

• Switch off the appliance with the ON/OFF switch.
The operating indicator integrated in the switch goes out.
• Pull out the mains plug and insert it into the holder provided.
• Clean and dry the appliance after every cooling cycle.
• Take the appliance out of operation before starting the cleaning process.
Pull out the mains plug and insert it into the holder provided on the appli-
ance.
• Do not clean the appliance with steam-jet or high-pressure cleaners. If it is
anticipated that steam-jet or high-pressure cleaners will be used in the sur-
roundings, then the appliance must be taken out of operation and discon-
nected from the mains power supply beforehand.
• The cooling assembly should be cleaned at least twice a year using a hand
brush and vacuum cleaner to remove dust and particles which have been
drawn in. To do this, the 4 fixing screws on the top of the top plate (2 at the
front, 2 at the back) must be completely unscrewed with a screwdriver (bit
width 7 mm) and the top plate must be removed. During this operation the
sliding handles can remain on the plate. Cleaning is then done from above.
• Either clean the appliances dry or dry well after cleaning so as to avoid the
development of mould and uncontrolled growth of germs and bacteria.
The cleaning must only be carried out when the appliance is at the right
temperature, as the moisture from the ambient air condenses inside on the
cold stainless steel walls. The interior of the appliance can only be cleaned
effectively and permanently dried if the temperature of the internal surfaces
of the appliance is the same as the ambient temperature. After cleaning
and drying, close the base outlet firmly with the supplied plug.
• The base outlet situated below the stacking tube is provided for the remov-
al of small crockery fragments or other small parts which have fallen into
the stacker.
If product residues are inadvertently situated on the base of the stacking
shaft, they can also be discharged via the outlet. The affected area can be
cleaned with a cloth soaked in liquid and the remaining moisture can also
be removed via the outlet.
• The cover should also either be cleaned dry or dried well after cleaning,
then close the appliance tightly with the cover. Cleaning in a commercial
dishwasher is not permitted. See also «Valuable information about "refined
stainless steel"».
• If the appliance is not operated for a relatively long time the cooling cham-
ber must be cleaned as described above at regular intervals.
43.3000.3