Tabla de contenido
Publicidad
TEKNISK VEJLEDNING MT050
MANUALE TECNICO MT050
Justeringen udføres ved at dreje på stilleskruen 17,
med uret for at forøge værdien, mod uret for at sænke
Questo apparecchio, in funzione di un
værdien.
segnale di pressione di valle, provvede a
scaricare all'atmosfera il gas racchiuso
M/A indgrebsområde Who: 0,3 ÷ 43 bar.
nella camera di motorizzazione del monitor
consentendone
così
un
4.0
MODULOPBYGNING
intervento.
Ovviamente
dell'acceleratore deve essere più alta di
Den modulære opbygning af regulatorer i serien
quella del monitor.
La taratura viene effettuata ruotando la
REFLUX 819 giver mulighed for at anvende en
vite di regolazione 17, in senso orario per
nødregulator for monitoren PM/819 eller en slam-shut-
aumentare il valore, in senso antiorario per
ventil på samme modul uden at ændre i indstillingerne,
diminuirlo.
også efter at regulatoren er blevet monteret.
M/A campo di intervento Who: 0,3 ÷ 43 bar.
4.1
INDBYGGET SLAM-SHUT-VENTIL
Ved indgreb vil slam-shut-ventilen, der er indbygget
4.0
MODULARITÀ
på regulatoren, for at kunne blive betragtet som en
sikkerhedsanordning, ikke kun lukke for tilførslen til
La concezione di tipo modulare dei
regulatoren, men også for dennes kontrolpilotenhed.
regolatori della serie REFLUX 819 assicura
la possibilità di applicare il regolatore di
4.2
INDBYGGET SLAM-SHUT-VENTIL SB/82
emergenza monitor PM/819 o la valvola di
blocco allo stesso corpo senza modificarne lo
Ventilen er en indretning (fig. 9), der straks blokerer
scartamento, anche in tempi successivi
all'installazione del regolatore.
for gasstrømmen, hvis trykket nedstrøms, som følge
af en form for svigt, når det punkt der er indstillet
som aktiveringspunkt for ventilen. Ventilen kan også
4.1
VALVOLA DI BLOCCO
INCORPORATA
aktiveres manuelt.
For trykregulatoren REFLUX 819 er der mulighed for
In caso di intervento la valvola di blocco
at have ventilen SB/82 indbygget enten på regulatoren
incorporata al regolatore, per essere
eller med monitor på linjen.
considerata un dispositivo di sicurezza
De
vigtigste
karakteristika
secondo PED, chiude l'alimentazione oltre
che al regolatore anche al suo pilota di
blokeringsindretning er:
comando.
TECHNICAL MANUAL MT050
On the basis of a pressure signal from
downstream this device discharges the gas
into the monitor's motorization chamber
into the atmosphere, thereby permitting
più
rapido
rapid intervention. The set point of the
la
taratura
accelerator must obviously be higher than
that of the monitor.
Setting is made by turning the adjustment
screw 17, clockwise to increase the value,
anticlockwise to reduce it.
M/A range of intervention Who: 0,3 to 43
bar.
4.0
MODULARITY
The modular-type design of REFLUX 819
series regulators means that it is also
possible to feitner the emergency monitor
regulator PM/819 or it the slam-shut
incorporated with the body itself even after
the installation of the regulator without any
modifications.
4.1
INCORPORATED SLAM-SHUT
VALVE
When closing the slam shut incorporated
into pressure regulator to be considered as
safety accessory according to Directive
ved
denne
PED, cuts off the feeding of gas both to
pressure regulator and to its pilot.
TECHNICAL MANUAL MT050
Setting is made by turning the adjustment screw
17 , clockwise to increase the value, anticlockwise to
reduce it.
M/A range of intervention Who: 0,3 to 43 bar.
4.0
MODULARITY
The modular-type design of REFLUX 819 series
regulators means that it is also possible to feitner the
emergency monitor regulator PM/819 or it the slam-
shut incorporated with the body itself even after the
installation of the regulator without any modifications.
4.1
INCORPORATED SLAM-SHUT VALVE
When closing the slam shut incorporated into pressure
regulator to be considered as safety accessory
according to Directive PED, cuts off the feeding of gas
both to pressure regulator and to its pilot.
4.2
INCORPORATED SB/82 SLAM-SHUT VALVE
This is a device (fig. 9) which immediately blocks
the gas flow if, following some kind of failure, the
downstream pressure reaches the set-point for its
intervention, or is operated manually.
On the REFLUX 819 regulator, it is possible to have
the SB/82 slam-shut incorporated both with the
service regulator and on the one functioning as in-line
monitor.
The main characteristics of the slam-shut device are:
Fig. 9 / Fig. 9
Fig. 9
16
26
TECHNISCHES HANDBUCH MT050
Dieses
Gerät
ermöglicht,
plötzlichem Anstieg des Regeldrucks das in
der
Steuerkammer
des
eingeschlossene Gas in die Atmosphäre
abgelassen wird, um so den Arbeitsbeginn
des Monitors zu beschleunigen. Natürlich
muss der Schließbeschleuniger auf einen
höheren Wert als der Monitor eingestellt
sein.
Die Einstellung erfolgt durch Verstellen
der Einstellschraube 17, und zwar im
Uhrzeigersinn zum Erhöhen des Werts und
gegen den Uhrzeigersinn, um den Wert zu
senken.
M/A Ansprechbereich Who: 0,3 ÷ 43 bar.
4.0
BAUKASTENSYSTEM
Das modulare Konzept der Druckregler der
Serie REFLUX 819 ermöglicht sowohl den
direkten Anbau eines Sicherheitsmonitors
PM/819 als auch eines SAV an das
Stellgliedgehäuse ohne Änderungen am
Regelsystem.
4.1
INTEGRIERTES SICHERHEITSABSPERR-
VENTIL
Damit das im Druckregler integrierte
Sicherheits-absperrventil
Duckgeräterichtlinie als Ausrüstungsteil mit
Sicherheitsfunktion definiert werden kann,
schließt es beim Auslösen nicht nur die
Gaszufuhr zum Hauptregler, sondern auch
zum Pilotregler ab.
dass
bei
Monitors
SAV
gemäß
Publicidad
Tabla de contenido
