Moving Forward; Motorcompressor Forward Moving; Stopping The Motorcompressor; Adjustment - CAMPAGNOLA MC 520 Manual De Instrucciones

4 - USING THE MOTORCOMPRESSOR

4.5 Moving forward

WARNING!
When the motorcompressor operates, it shall be placed on flat ground. The slope inclination shall not be higher than
20% laterally, uphill or downhill, as this may cause damages to the motorcompressor parts.

4.5.1 Motorcompressor forward moving

• By operating lever (4) the motorcompressor will move forward. Its speed is controlled by the operator.
• The motorcompressor movement is stopped by releasing the lever (4).
• The motorcompressors are fitted with a two-wheel drive with differentiated effect.
WARNING!
When moving the motorcompressor, the operator shall hold it by the handle bars constantly, as it has no brakes.

4.6 Stopping the motorcompressor

Perform the procedures below in the order given:
a) Move the switch (16) to the OFF position.
b) Close the cock (8) on the fuel tank.

4.7 Adjustment

Air pressure adjustment
To change the air pressure, pull the knob (25) on the regulator. Turn it clockwise to increase the pressure; counter-clockwise to
decrease it. Once the correct pressure has been reached, lock the knob by slightly pushing it downwards.
Air lubricator adjustment
A drop of oil every 20-30 seconds should fall from the nozzle inside the transparent cap (24). To adjust the rate at which the oil
should drop, turn the screw located on the cap (24). By using a screw-driver, turn it counter-clockwise to increase; clockwise to
decrease. Meanwhile, idle a tool.
25 - 72