Stryker 0233–050–064 Manual De Instrucciones página 15

5. Allow the cable to cool to room temperature before reuse.
4.5.5.3 Steris System 1
N N o o t t e e : : S S t t e e r r i i s s S S y y s s t t e e m m 1 1 i i s s n n o o t t i i n n t t e e n n d d e e d d f f o o r r u u s s e e i i n n t t h h e e U U n n i i t t e e d d S S t t a a t t e e s s . .
W W a a r r n n i i n n g g : Using another sterilization tray than specified below can result in
incomplete sterilization.
When placing the cable in the sterilization tray, do not coil the cable, and minimize the
number of contact points where the cable sheath touches itself. Failure to observe
this warning can result in incomplete sterilization.
1. Clean and prepare the device as recommended in this user manual.
2. Place the device in the Steris Flexible Processing Tray (model #C1140).
3. Arrange the cable in the tray to allow for maximum sterilant exposure around all
surfaces of the cable.
4. Following the manufacturer instructions, sterilize the device using System 1 with Steris
20 Sterilant.
5. Remove the device from the Steris chamber once sterilization is complete to prevent
moisture from condensing inside the device.
6. Allow the cable to completely dry and cool to room temperature before reuse.
4.5.5.4 Sterrad
1. Clean and prepare the device as recommended in this user manual.
2. If using a sterilization tray, follow any additional instructions provided with the tray. Use
only trays that are approved for sterilization with Sterrad 100S, NX, or 100NX.
3. Double wrap the device (or tray) prior to sterilization.
4. Following the instructions of the manufacturer, sterilize the device using the Sterrad
100S, NX, or 100NX system. Select the standard cycle.
5. Allow the cable to cool to room temperature before reuse.
4.5.5.5 Ethylene Oxide (EO)
1. Clean and prepare the device as recommended in this user manual.
C C o o r r r r e e c c t t I I n n c c o o r r r r e e c c t t
EN- 13