INSTRUCTIONS FOR USE
Contact IDI if you need to repair or replace the device contact us using the information from the
contact details section.
Cleaning and Disinfection:
WARNING:
•
After each use, clean the device as directed in this instruction for use.
•
Do not submerge the device in liquid. Equipment damage can occur.
•
Use caution in areas where liquid can get into the mechanism.
•
Do not use bleach or products that contain bleach to clean the device. Injury or
equipment damage can occur.
•
Make sure that the device is dry before you store it or use it again.
After each use, clean the device. Clean and disinfect using a OR approved disinfecting/cleaning
solution following the manufacturer's recommendation for achieving low-level disinfection and
according to the facility protocol. After each use or exposure to a patient the equipment should be
cleaned with disinfecting wipes or sprays; any organic material or residue should be removed
completely from the surface of equipment.
•
Wipes:
Wipes may contain up to 2% sodium hypochlorite.
o
Wipes may contain benzalkonium chloride (< or = 0.6% conc.) and didecyl dimethyl
o
ammonium chloride (up to 0.6% conc.)
Wipes may contain benzalkonium chloride (up to 0.6% conc.), didecyl dimethyl ammonium
o
chloride (up to 0.6% conc.) and may also contain polyhexamethylene biguanide (up to 0.6%
conc.).
•
Sprays:
Sprays may contain up to 2% sodium hypochlorite.
o
Sprays may contain up to .2% benzalkonium chloride and up to 0.2% didecyl dimethyl
o
ammonium chloride (quaternary ammonium chloride solution (QACs) and may also contain
polyhexamethylene biguanide (up to 0.6% conc.).
Sprays may contain up to 2% hydrogen peroxide.
o
Read the cleaning product's directions and follow the instructions on the label. Use caution in areas
where fluid migration may occur:
Wipe device with a clean, dry cloth. Make certain the product is dry prior to reinstalling to avoid
damage.
CAUTION: Damage may result if product is cleaned with caustic chemicals or harsh abrasives
ATTENTION: If any IDI product is damaged or appears to be functioning abnormally, discontinue
use and contact IDI Customer Service at 1-978-829-0009.
Page 8
IFU Document Number: 03-0123-REV-E