To Begin Pumping - Ameda Pearl Instrucciones De Uso

7.4 To Begin Pumping

STEP 1: PUMP PLACEMENT
Place pump on a horizontal flat surface.
2
3
Single v. Double Pumping
DOUBLE PUMPING = expressing
from both breasts at the same time
SINGLE PUMPING = expressing
from just one breast at a time
4
5
16 | ENGLISH
STEP 2: CONNECT THE POWER ADAPTER
Insert the power adapter into the rear of the pump and
an AC power outlet. If operating on battery alone, use of
the power adapter is not required.
STEP 3: INSERT TUBING
M M
If the tubing port cover is not open, grasp the cover near the
top and gently pull the cover open and expose the tubing
port. Insert the tubing adapter into the front of pump base,
then turn slightly to right while pushing firmly.
A. For DOUBLE PUMPING:
Both tubes should be
attached to the tubing
adapter.
STEP 4: PLACE THE FLANGE ON BREAST
Center flange on breast and press firmly to create a tight seal.
Check breast flange fit, if pumping causes discomfort a larger
or smaller breast flange size may be needed. See section on
how to properly fit your flange. See section 7.5 below on how
to properly fit your flange.
NOTE: Make sure your upper body is upright.
STEP 5: POWER ON THE PUMP
Press the Power button to turn on the device.
It will begin in Stimulation Mode.
M
B. For SINGLE PUMPING:
Remove one tube from
the tubing adapter and
close one side using the
attached plug.