Publicidad
Idiomas disponibles
Idiomas disponibles
Fill
the
fuel
oil/gasoline mixture.(see previous section)
Hand tighten the gasoline cap just until it's
STARTING INSTRUCTION
snug.
Starting Your Tiller / Cultivator for the firt time
1. Fill the fuel tank with the proper oil/gasoline mixture. (see previous section)
Move run/stop lever into the "run" position.
2. Hand tighten the gasoline cap just until it's snug.
3. Move run/stop lever into the "run" position.
4. Slide the choke lever back to close the engine choke.
lide the choke lever back to close the engine
5. Locate the purge bulb on the upper right of the engine, in the front of the fuel tank. It sends fuel
into the carburetor, for easy starting Press the purge bulb until you see fuel flow through the clear
oke.
fuel return line. Since you're starting "cold", you may need to press six to eight times. As soon as
fuel starts flowing through the clear fuel line, stop pressing !
ixture
6. Don't pull the throttle trigger during the starting of the engine.
7. Pull the starter cord slowly until resistance is felt. Then give the recoil starter cord a few short,
re, If
5.Locate the purge bulb on the upper right of
brisk pulls until the engine fires. During cold starting. You may need to pull at least three or four
times before the engine fires.
rapid,
the engine, in the front of the fuel tank. It
8. Move the choke lever to the close(choke)
Note: When the choke is closed, never pull the cord more than four or five times. Overpull may
cause flooding. Also bear in mind that, when the engine fires, it only coughs or sputters, and will
d the
sends fuel into the carburetor, for easy starting
position.
not run on choke.
8. Move the choke lever to the close (choke) position.
Press the purge bulb until you see fuel flow
through the clear fuel return line.Since you're
starting "cold", you may need to press six to
eight times. As soon as fuel starts flowing
through the clear fuel line, stop pressing !
66.7
tank
with
the
proper
6.Don't pull the throttle trigger during the
starting of the engine.
7. Pull the starter cord slowly until resistance
is felt. Then give the recoil starter cord a few
short , brisk pulls until the engine fires.
During cold starting. You may need to pull at
least three or four times before the engine
fires.
Note: When the choke is closed , never pull
the cord more than four or five times.Overpull
may cause flooding.Also.bear in mind that,
when the engine fires, it only coughs or
sputters , and will not run on choke.
8
Simply push the start / stop switch to " st
This will stop the engine instantly. If it sh
ever fail to do so. Just pull out the chok
button. The engine will stop at once.
59
Publicidad
