Publicidad
Idiomas disponibles
Idiomas disponibles
correctly attached and do not have cracks or other
damages. Replace damaged covers.
Safety instructions for maintenance
WARNING:
can cause injury or damage to property or
the adjacent area. Do not do maintenance
on the product and cutting deck without
these conditions:
•
The power switch is set to the "0"
position and the key to the power switch
is removed.
•
The product is parked on a level surface.
•
The parking brake is engaged.
•
The cutting deck is disengaged.
•
The cable to the battery charger is
disconnected.
WARNING:
instructions that follow before you use the
product.
•
For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page
schedule. Refer to
21 .
Introduction
Instructions for how to remove and attach the cutting
deck are also on a label on the inner surface of the front
cover.
To remove and attach the cutting deck
1. Park the product on level ground.
2. Set the power switch to the "0" position.
3. Set the cutting height lever in the servicing position.
4. Release the clip on the front cover with the tool
attached to the power switch key, and remove the
cover.
12
The product is heavy and
Read the warning
Assembly
•
Electrical shocks can cause injuries. Do not do
maintenance on the battery. Do not touch the cables
when the motor is on. Do not do a function test with
your fingers.
•
Do not start the product if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
•
Let the product become cool before you do
maintenance on it.
•
The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
•
Always put the cutting deck in the servicing position
to clean it. Do not park the product near the edge of
a ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
•
Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
•
Do not change the adjustment of governors. If the
motor speed is too high, the product components
can become damaged. Refer to
page 35 for highest permitted motor speed.
•
The product is approved only with the equipment
supplied or recommended by the manufacturer.
5. Lift the cutting height stay and put it in the holder for
the cutting height stay.
Read the caution
Technical data on
1949 - 003 - 28.03.2023
Publicidad
