Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Do a check of the switch on the cutting deck lift.
Do a check of the blade engagement and the OPC switch.
Do a check of the forward drive and rearward drive on different speeds.
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
•
Before you clean with a wet cloth, clean with a
brush. Remove grass and dirt on and around the
propulsion system and the inlet to the cooling fan of
the motor.
•
Use a wet cloth to clean the product.
•
Do not use water at electrical components or
bearings. Detergent usually increases the damage.
•
Make sure that the battery and battery charger are
clean before the battery charger is connected to the
product.
•
To clean the cutting deck, put it in servicing position
and hose it down with water. Make sure that the
power switch is set to the "0" position.
•
When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To remove the covers
To open and close the battery cover
CAUTION:
the rails before you open the battery cover.
1. Release the 2 clips on the front of the battery cover
with the tool attached to the power switch key.
22
Do not use a high-pressure
Remove load attached to
2. Lift the front of the battery cover and tilt it rearward.
3. Close in the opposite sequence.
To remove the front cover
1. Release the clip on the front cover with the tool
attached to the power switch key.
2. Remove the front cover.
To remove and install the frame cover
1. Tilt the seat forward.
2. Remove the 3 screws.
Each 50 h or year-
ly
O
O
O
1949 - 003 - 28.03.2023
Publicidad
