Publicidad
Idiomas disponibles
Idiomas disponibles
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
Battery indication when the product is
set to on
The display shows the state of charge in % when the
product is on. Each green indicator is 20% state of
charge. When the state of charge is 20% or lower, the
indicator to the far left is yellow. When the state of
charge is 5% or lower, the indicator to the far left is red.
When the battery is empty, the indicator to the far left is
grey.
To charge the battery
WARNING:
damaged battery charger can cause an
electrical shock, battery leakage or too high
temperatures. Regularly examine the battery
charger and the battery for damage.
CAUTION:
you use it the first time. A new battery is not
fully charged.
16
An incorrectly used or
Charge the battery before
CAUTION:
chargers. Refer to
35 .
CAUTION:
possible when the temperature of the battery
is in the permitted charge temperature range
(0–38 °C).
CAUTION:
where temperatures are between 0°C and
40°C.
Note:
The battery can go into sleep mode when the
product is in storage or the state of charge is very low.
To start the battery, the start button must be pushed
for 2 seconds. If the battery does not start it must be
charged continuously until it is fully charged. The charge
time is longer when the battery is in sleep mode.
1. Connect the battery charger to a grounded mains
socket and to the product.
2. Set the charger ON/OFF switch to ON.
3. Set the charger ON/OFF switch to OFF before you
disconnect the charger.
Note:
A second battery can be installed in the
product. Speak to your Husqvarna dealer for installation.
Only use approved
Technical data on page
The charge process is only
Use the battery in conditions
1949 - 003 - 28.03.2023
Publicidad
