Publicidad
Idiomas disponibles
Idiomas disponibles
Message type
Display indicator message
Warning message
Error message
Start prevented
Display modes
A
B
C
The center of the display shows different information in
the different display modes.
•
The idle mode (A) shows when the power switch
is set to the "1" position. In idle mode, the display
shows the total operation time.
•
The drive mode with cutting deck in transport
position (B) shows when the product is started.
In the drive mode with cutting deck in transport
position, the display shows the current speed, in
km/h.
•
The drive mode with cutting deck in mow position (C)
shows when the cutting deck or other accessory is
on. When only green indicators are on, the power
consumption of the cutting deck or accessory is as
recommended. If yellow or red indicators are on,
1949 - 003 - 28.03.2023
Description
Indicator symbols on the display show an engaged function or information about
the condition of the product. When there is a display indicator message, the
product can usually operate but there are recommended actions. Refer to
overview on page 4 and Display indicator messages on page 29 .
A combination of yellow symbols that first show as large symbols in the center
of the display. Shows a condition that is not correct. When there is a warning
message, the product can usually operate but it is slower than usual. Refer to
Warning messages on the display on page 30 .
A combination of red symbols that first show as large symbols in the center of
the display. Shows a safety warning or a problem with the product. When there is
an error, the product is usually set to idle mode and cannot start until the error is
Error messages on the display on page 30 .
gone. Refer to
One large symbol on the display that shows a condition that prevents a start of the
Messages when start is prevented on page 31 .
product. Refer to
the power consumption is higher than recommended
and the operation time decreases.
Charge view
A
When a charger is connected to the product, and the
power switch is set to the "1" position, the center of the
display shows the charge view.
(A): The charge view shows the state of charge in %.
The charge symbol (B) comes on when the product
charges. The charge symbol (B) goes off when the
charger is connected but does not charge.
Start prevented
Before the product can start, the operation conditions
must be obeyed. Refer to
page 19 . If the start button is pushed when operation
conditions are not obeyed, the display shows a symbol
for start prevented. Refer to
prevented on page 31 .
Operator presence control (OPC)
The OPC sets the product in safe mode when the
operator lifts from the seat. The motor stop and the
cutting deck motors stop if the blades are engaged.
To do a check of the operation conditions on
Refer to
page 11 .
Display
B
To start the product on
Messages when start is
5
Publicidad
