Publicidad
Idiomas disponibles
Idiomas disponibles
To select a drive mode
You can set the product in 2 different drive modes:
Standard drive mode or a battery save function, SavE.
The SavE function gives longer operation time. The
SavE function decreases the speed of the product and
the speed of the blades.
1. Set the power switch (A) to the "1" position. The
display comes on.
2. Push the drive mode button (B) to change drive
mode.
Note:
The drive mode indicator on the display
shows which drive mode is on. Refer to
overview on page 4 .
Note:
If the indicator for Low battery drive mode
Display indicator messages on
comes on, refer to
page 29 .
To stop the product
1. Park the product on level ground. The parking
brake is automatically applied when the product is
stationary.
2. Pull the lift lever for the cutting deck rearward to lift
the cutting deck to transport position.
3. Set the power switch to the "0" position.
To get a good mow result
•
Do not cut a wet lawn. Wet grass can give a bad
result.
•
Start with a high cutting height and decrease it
gradually.
•
To get the best result, use standard drive mode.
Move the product forward at low speed. If the grass
is not too high and thick, you can get a good result
also at a higher speed.
20
B
A
Display
•
To get the best result, cut the grass frequently and
use the mulch function. Refer to
install the BioClip plug on the cutting deck on page
26 .
To attach load to the rails
The product has rails and rail brackets on the battery
cover to attach load.
1. Adjust the rail brackets to fit the load.
a) Loosen the screw and move the rail bracket
forward or rearward on the rail.
b) Tighten the screw.
2. Put a strap through the hole in the rail bracket (A).
B
A
3. Put the strap through the rail bracket (B) on the
opposite side.
4. Use the rail brackets to attach the load with straps.
CAUTION:
rails. Refer to
35 .
To remove and
Do not overload the
Technical data on page
1949 - 003 - 28.03.2023
Publicidad
