Husqvarna R 200iX Manual De Usuario página 27

Introduction
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna servicing
dealer.
Troubleshooting schedule
Problem
The display does not come on
when the power switch is set to
position "1".
Drive mode does not start when
you push the start button.
The cutting deck motors do not
start.
1949 - 003 - 28.03.2023
Troubleshooting
Cause
The fuse for the power control
unit is broken.
The display, or the cable to the
display unit, is broken.
The power switch is broken.
Incorrect start procedure.
The start button is pushed down
for less than 1 second.
The control panel is broken.
The cutting deck is not in mow
position.
The cable to the cutting deck is
not connected correctly.
The cutting deck is full of grass.
The grass is too high.
The temperature of the controls
for the cutting deck motors are
too high.
The cutting deck motors are bro-
ken.
The controls for the cutting deck
motors are broken.
There is no power in the cable to
the cutting deck.
Note:
Make sure that the battery is charged before
you do troubleshooting on the product. Refer to
charge the battery on page 16 .
Action
Replace the fuse for the power control unit,
To replace the fuse for the power
refer to
control unit on page 23 . Speak to your Husq-
varna servicing dealer if the problem contin-
ues.
Speak to your Husqvarna servicing dealer.
To start the product on page 19 and
Refer to
Start prevented on page 5 .
Push down the start button for 1 second. A
sound and/or a display change shows that
drive mode is on. When the sound is set to
off, you do not hear the notification sound for
start. Refer to
on page 15 .
Speak to your Husqvarna servicing dealer.
Move the cutting deck to mow position, refer
To put the cutting deck in mow position on
to
page 24 .
Connect the cutting deck to the product, refer
To remove and attach the cutting deck on
to
page 12 .
Clean the cutting deck, refer to
product on page 22 .
Adjust the cutting height to the grass condi-
tions.
Stop the product and wait for the tempera-
ture to decrease. Restart after 20 minutes.
Speak to your Husqvarna servicing dealer.
To
To set the sound to on or off
To clean the
27