Husqvarna R 200iX Manual De Usuario página 26

5. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
25 .
6. Attach the front cover.
To remove the BioClip plug
• Remove the BioClip plug to change a Combi cutting
deck from BioClip to rear discharge of the grass.
To remove and install the BioClip plug on the
cutting deck
1. Put the cutting deck in servicing position. Refer to
put the cutting deck in servicing position on page 24 .
2. Remove the 3 screws that hold the BioClip plug and
remove the plug.
3. Attach 1 M8x15 mm screws in the top screw hole for
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck in the mow position.
5. Install the BioClip plug in the opposite sequence.
To examine the blades
CAUTION:
balanced blades can cause damage to the
product. Replace damaged blades. Let an
approved service agent help you sharpen
and balance blunt blades.
1. Put the cutting deck in servicing position.
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
26
To do a
Damaged or incorrectly
3. Tighten the blade bolts with tightening torque 25 Nm.
To replace the blades
1. Remove the cutting deck. Refer to
attach the cutting deck on page 12 .
2. Lock the blade with a wooden block.
To
3. Loosen and remove the blade bolt (A), the washers
(B) the blade (C) and the blade support (D).
B
4. Install in the opposite sequence. Install the new
blade with the bent ends in the direction of the
cutting deck.
WARNING:
can cause objects to eject from the
cutting deck and cause serious injury.
Use only the blades given in
data on page 35 .
To remove and
A
C
D
Incorrect blade type
Technical
1949 - 003 - 28.03.2023