Publicidad
Idiomas disponibles
Idiomas disponibles
4. Put a bathroom scale below the front edge of the
cutting deck.
5. To make sure that no weight is applied on the
support wheels, put a wooden block between the
frame and the bathroom scale.
6. To adjust the ground pressure, turn the adjustment
screws found behind the front wheels on the right
and left sides.
7. Turn the screws right or left until the ground pressure
is between 12 and 15 kg (26.5-33 lb).
To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is correct.
Technical data on page 35 .
Refer to
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
1949 - 003 - 28.03.2023
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm or 1/5 in. higher than
the front edge.
To adjust the parallelism of the cutting
deck
1. Remove the front cover.
2. Loosen the nuts on the lift stay.
3. Turn the lift stay to extend it or make it shorter.
Extend the lift stay to lift the rear edge of the cover.
Make the lift stay shorter to lower the rear edge of
the cover.
4. Tighten the nuts on the lift stay when the adjustment
is done.
25
Publicidad
