Publicidad
Idiomas disponibles
Idiomas disponibles
Symbols
Warning messages on the display
A warning message is a combination of yellow symbols that first show as large symbols in the center of the display.
When there is a warning, the product can operate but it is slower than usual. To prevent error, stop the product and
wait for the warning symbols to go off. If the product is stopped, it cannot start again until the warning message is
gone.
Note:
For warnings on the cutting deck motor/motor controller, lift the cutting deck/accessory to transport position to
restart or operate.
Symbols
Error messages on the display
An error message is a combination of red symbols that first show as large symbols in the center of the display. When
there is an error, the product is automatically set to idle mode and cannot start until the error is gone. You can see
error messages in the error menu. Refer to
Note:
For errors on the cutting deck motor/motor controller, lift the cutting deck/accessory to transport position to
restart or operate.
30
Name
Cause / Action
Decreased per-
The product is automatically set to Decreased performance
formance mode
mode. The level of charge is low and/or the temperature in
the battery, the drive motor or the drive motor controller is
too high. In this drive mode the blades are disengaged and
the speed decreases gradually. Refer to the combination of
symbols for more information.
Name
Cause / Action
Battery tempera-
The battery temperature is higher than recommended. The
ture warning
product operates slower than usual until the temperature
is decreased. Stop the product and wait for the battery tem-
perature to decrease before you start.
Temperature
The temperature in the drive motor or the drive motor con-
warning for the
troller is higher than recommended. The product operates
drive motor or the
slower than usual until the temperature is decreased. Stop
drive motor con-
the product and wait for the temperature of the drive motor
troller
to decrease before you start.
Temperature
The temperature in the cutting deck motor or the controller
warning for the
for the cutting deck motor is higher than recommended.
cutting deck mo-
The product operates slower than usual until the tempera-
tor or the control-
ture is decreased. Lift the cutting deck / front accessory to
ler for the cutting
transport position and wait for the temperature to decrease
deck motor
before you start.
To read error messages on page 15 .
1949 - 003 - 28.03.2023
Publicidad
