Husqvarna R 200iX Manual De Usuario página 13

6. Disconnect the cable to the cutting deck.
7. Disengage the lock to the cutting deck with your left
hand. Pull the cutting deck out with your right hand.
8. Put a wooden block between the equipment frame
and the chassis. This makes sure that the cutting
deck does not spring back when removed.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
1949 - 003 - 28.03.2023
Operation
Before you operate the
WARNING:
a risk of injury if your hand is caught
between the equipment frame and the
chassis.
9. Remove the 2 screws on the equipment frame.
10. Hold the front edge of the cutting deck and pull it out.
11. Remove the wooden block.
12. Attach the cutting deck in opposite sequence.
Be careful. There is
13