Husqvarna R 200iX Manual De Usuario página 21

Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Daily maintenance before use
Make sure that nuts and screws are tightened.
Clean the product and the inner surfaces of the cutting deck.
Make sure that the safety devices are not broken.
Examine the steering cables.
Examine the blades in the cutting deck.
Make sure that the tire pressure is correct.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's manual. Let an approved service agent do the maintenance.
Maintenance
Clean the outer and inner surface of the cutting deck. Clean below the cutting deck cover and
around the blades.
Make sure that the tire pressure is correct.
Connect the product to Husqvarna Service Hub (HSH) and do an update of the firmware and a
calibration if it is necessary.
Charge the battery to a minimum of 80 %. Do a check of the battery status in HSH.
Make sure that nuts and screws are tightened to the correct torque.
Do an inspection, lubricate and adjust all wires.
Do a check of the steering chain of the inner side of the frame tunnel.
Lubricate the pedals on the inner side of the frame tunnel.
Lubricate the operators seat.
Remove the drive wheels and lubricate the axles with grease.
Lubricate the cutting deck frame and the cutting deck presence control.
Lubricate the pivot wheels on the cutting deck.
Examine the blades. Sharpen and balance the blades if it is necessary.
Do a check of and adjust the parallelism of the cutting deck.
1949 - 003 - 28.03.2023
Maintenance
Read and understand the
Each 50 h or year-
ly
X
X
O
O
O
O
O
O
O
O
O
O
O
X
21