Publicidad
Idiomas disponibles
Idiomas disponibles
•
Release the lock to the electric parking brake system
(A) and move the lever (B) to the right position to
engage the electric parking brake system.
To start the product
1. Disconnect the cable to the battery charger.
2. Sit on the seat.
3. Lift the cutting deck to transport position. Refer to
lift and lower the cutting deck on page 18 .
4. Set the power switch to the "1" position (A). The
product is set to idle mode.
5. Make sure that you do not push the pedals.
6. Push the start button (B) until there is a sound and
the display view changes. This shows that drive
mode is on.
1949 - 003 - 28.03.2023
A
B
To
B
A
Note:
You do not hear the sound if the sound is
To set the sound to on or off on
set to off. Refer to
page 15 .
Note:
The battery can go into sleep mode when the
product is in storage or the state of charge is very low.
To start the battery, the start button must be pushed
for 2 seconds. If the battery does not start, it must be
charged continuously until it is fully charged. The charge
time is longer when the battery is in sleep mode.
To operate the product
1. Start the product. Refer to
page 19 .
2. Carefully push down 1 pedal. Use pedal (A) to move
forward, and pedal (B) to move in reverse. The
speed increases the more the pedal is pushed down.
Note:
The parking brake is automatically released
when you push a pedal.
3. Release the pedal to engage the brakes.
4. Select cutting height (1–10) with the cutting height
lever.
5. Push the lock button on the lift lever for the cutting
deck and lower it to mow position.
To start the product on
A
B
19
Publicidad
