Publicidad
Idiomas disponibles
Idiomas disponibles
XRpad2 HWC-M Detectors User Manual
16.0
Minimum System Requirements
The following are the minimum requirements for the host computer that controls the X-ray
detector.
Gigabit Ethernet Infrastructure and a free Gigabit Ethernet Port or WLAN Infrastructure.
1
Intel compatible Multi Core Processor (> 2 GHz).
2
RAM > 4 GB.
3
Windows 7 (32-bit/64-bit)/Windows 10 (64 bit)/Linux (Optional; Please contact your sales,
4
distributor, or device manufacturer).
If a Firewall is used, make sure that it allows a connection to the detector.
5
Access Point:
6
WPA2 encryption support.
a
802.11n standard with 20 MHz channel bandwidth 36-48, 52-64, 100-116, 132-140,
b
149-165.
MIMO 3×3 WAP (Recommended).
c
Complying with IEC 60601-1 or IEC 61010-1 or IEC 60950-1 or IEC 62368-1.
d
17.0
Operating the X-ray Detector
Before connecting the X-ray detector, ensure that the Digital Radiography Software is installed
as described in its manual. If not, install the software first. The X-ray detector can be used in
different configurations depending on the desired application. The following sections describe
the different use cases.
WARNING
WARNING
WARNING
Do not exceed the maximum uniform load weight of 150 kg
distributed across the surface of the X-ray detector.
Do not exceed the maximum load weight of 100 kg distributed at one
location in a 40 mm diameter of the X-ray detector surface.
The AED mode requires a sufficient X-ray dose rate to the detector
surface to trigger image acquisition. The required dose rate can vary at
different use conditions.
Depending on conditions, including but not limited to, environmental
conditions, installation method, X-ray system setup, and subject to be
imaged, the use of AED mode may result in false trigger or no trigger
of X-ray image acquisition. The risk of false trigger or no trigger of
X-ray image acquisition must be assessed for the specific indication
for use or application.
www.vareximaging.com
Minimum System Requirements
53
Publicidad
