Publicidad
Idiomas disponibles
Idiomas disponibles
XRpad2 HWC-M Detectors User Manual
19.1.2
After Turning On the Power
Inspection
Check that the wireless
connectivity or the AP
symbol (
)is shown in
the display if wireless mode
is used.
Check that the LAN
connectivity symbol ( ) is
shown in the display if the
wired mode is used.
Check the battery charge
condition (Battery Half or
better (
).
Check that the detector LED
is ON.
Perform test exposure as
described in the Digital
Radiography Software
Manual.
19.1.3
After Turning Off the Power
Inspection
Check that the X-ray
detector is turned off
normally and that all LEDs
are OFF.
Make sure that the X-ray
detector is clean and
disinfected.
Result
Date
Date
/
/
Good/Bad Good/Bad Good/Bad Connect the X-ray detector
Good/Bad Good/Bad Good/Bad Connect the Gigabit Ethernet
Good/Bad Good/Bad Good/Bad Exchange the battery pack
Good/Bad Good/Bad Good/Bad Set the Detector to Exposure
Good/Bad Good/Bad Good/Bad If any error messages appear,
Result
Date
Date
/
/
Good/Bad
Good/Bad
Good/Bad
Good/Bad
www.vareximaging.com
Inspection and Maintenance
Date
/
and the WLAN Access Point
as described in the Access
Point Manual.
cable and the tethered power
and communication cable
properly.
with a charged one.
Ready as described in the
Digital Radiography Software
Manual.
follow the instructions in the
Digital Radiography Software
Manual. If there is a problem,
contact your dealer,
distributor, or device
manufacturer.
Date
/
Good/Bad See
"Section 17.5, Powering
Off the X-ray Detector" on
page 59
for turning off the
X-ray detector.
Good/Bad See
"Section 19.5, Cleaning
and Disinfecting
Instructions" on page 65
cleaning the X-ray detector.
Remedy
Remedy
for
63
Publicidad
