dormakaba LA GARD 700 Serie Guia Del Usuario página 51

Display:
•
Keypad:
•
4. After approximately 5 seconds or less:
Lock:
•
Display:
•
Keypad:
•
flash and buzzer beep.
5. At the end of the Lag Time:
Lock:
•
Display:
•
Keypad:
•
rejected with a corresponding red LED flash and buzzer beep.
6. After approximately 3 seconds:
Lock:
•
Display:
•
Keypad:
•
7. Auto Open sequence ends
3.15.1.3 Auto Open Feedback with battery level low or critical
The Auto Open feature works as described in the previous section, with the following differences when the
battery level is low or critical:
Battery Level low
If reported by the lock at wake-up, a key press is required to advance to the logon prompting.
•
Battery low warning will appear briefly before the opening of the Target Lock, accompanied by LED
•
flashes and beeps (if buzzer enabled).
Battery Level critical
If reported by the lock at wake-up, no further actions are possible until the battery is replaced.
•
If critical battery level is detected as a result of opening Lock 1, it will be reported when the Keypad
•
wakes-up to open the Target Lock. The Target Lock will not open, and the Auto Open Sequence is
cancelled. No further actions are possible until the battery is replaced.
3.15.2 Configure Auto Open – Display Keypad
Note: Review sections
before configuring Auto Open.
Ensure that the target lock has been installed prior to beginning the Auto Open setup
Follow these steps to configure a multi-lock system for Auto Open using a Display Keypad:
1. Enter an Authorized User ID and Combination.
2. Navigate through the Main Menu and select "System".
3. Select "Locks" from the sub-menu.
4. Select "Auto Open" from the sub-menu.
5. If more than two locks are installed, you will be asked to select a lock. To choose a target lock for Auto
Open, press the corresponding number on the Keypad. Note: Lock 1 is not available to be selected as the
Target Lock.
"In Auto Open Sequence"
Any keypresses will be rejected with corresponding red LED flash and buzzer beep.
All Locks are locked
Blank screen, "In Auto Open sequence" will reappear if a key is pressed
The keypad will go to sleep. Any keypresses will be rejected with a corresponding red LED
The target lock will open
"Lock X Open", where X represents the Target Lock being opened
Green LED flashes 3 times, with 3 high beeps (if buzzer enabled). Any keypresses will be
The Target Lock will lock
Displays the time and date
Operates normally
3.15.1 "Aspects of Auto Open" and 3.15.1.1 "Auto Open Interactions with other features"
dormakaba USA Inc. System User Guide 7040.1121 Rev E2 10/22 | 49