dormakaba LA GARD 700 Serie Guia Del Usuario página 56

8.
Select the applicable User number (please note that 00 will always be the Master User). Fill out the
following information:
Name – Select the Name from the drop-down menu. Names are listed alphabetically by Last
•
Name
User Type – If the User number is 00, Master will automatically be selected. For other numbers,
•
select between User and Manager from the drop-down menu
Combination – If Master User was selected, this field will not be fillable. For other Users, fill in a
•
Combination
Time Delay Override – Check the box to activate
•
Disabled – Check the box to active
•
Privileges – Select the box beside each lock type the User will gain access to
•
9.
Select the Save icon from the top-right of the screen.
5.2 Install a User into the Keypad
Follow these steps to install a User from the LA GARD Software client into the Keypad:
1.
From the LA GARD software main menu, select System.
2.
Select the applicable System from the middle sub-menu.
3.
From the top-right menu, select the PC Link icon.
4.
Double-check the COM port or select a different port with the drop-down menu.
5.
Select Program from the left-hand column.
6.
Check the box beside User Changes.
7.
Connect the Keypad to the PC by doing the following:
a. Plug the 700 Series USB Dongle into the USB Port of the PC
b. Plug the USB-connector end of the cable into the dongle
c. Plug the mini-USB end of the cable into the mini-USB port on the Keypad
8.
On the Keypad, enter a valid User ID and the corresponding combination.
9.
Using the Arrow buttons on the Keypad, navigate through the Main Menu and select PC Link by pressing
the <return key> (←). The top of the Keypad will illuminate red.
10.
In the software client PC Link window, use the dropdown to select the User ID and enter the
corresponding password. This should be the same ID and password used in step 8.
11.
In the software client, select the Send icon located at the top-right of the screen. A progress bar will
appear on screen. The Keypad will beep three times and flash a green LED once complete.
5.3 Firmware Update
When a new firmware is available, these files will be available to registered LA GARD Software users.
Using the LA GARD Software client, keypad and lock firmware can be updated. There are four firmware files
that can be updated:
Bootloader for the Keypad
•
Application for the Keypad
•
Bootloader for the Lock
•
Application for the Lock
•
dormakaba USA Inc. System User Guide 7040.1121 Rev E2 10/22 | 54