VM Motori R754EU6C Manual De Instrucciones página 129

AIR BLEEDING FROM THE FUEL SUPPLY CIRCUIT
IMPORTANT
GB
This operation must be carried out after
each fuel filter cartridge replacement.
Follow the procedure below :
IMPORTANT
Carry out the operation with the engine
off. Ignition key removed, wait at least
6 minutes before disconnecting the
negative battery cable.
1 - Carry out the operation with the engine
cold.
2 - Do not come into contact with hot
engine parts and fuel. Wear gloves and
protective clothing suitables.
3 - Prepare a container with appropriate
capacity under the fuel filter.
4 - Partially loosen the screw (E) to allow
the fuel to be bled to drain.
5 - Manually activate the pump (F) until the
fuel drained has no air bubbles.
6 - Tighten the screw (E).
IMPORTANT
Thoroughly dry any fuel residues befo-
re starting the engine.
English
E
CAUTION - PRECAUTION
Do not use the starter motor to try to
bleed air from the fuel circuit.
CAUTION - PRECAUTION
Do not loosen high-pressure pipe
unions of the supply circuit (common
rail system).
60
R754EU6C
F
42432104F