Descargar Imprimir esta página

METRO PROFESSIONAL GCO2001 Manual De Instrucciones Original página 9

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 242
5. Installation and operation
5.1 Safety instructions
After baking open the door with caution, to avoid the violent outflow of heat which might cause
burns.
While the oven is in operation, pay attention to the hot zones (marked on the appliance) of its external
surfaces.
Place the machine on a bench or similar support, at a height of at least 85 cm from the floor.
The bench or support must be able to support the weight of the machine and to house it correctly.
The appliance contains electrical parts and must never be washed with a jet of water or steam.
The appliance is electrically connected: before attempting any cleaning operation, cut power to the
appliance.
Do not use the door handle to move the appliance (the glass panel could break).
When the door is completely open, do not place any objects on its surface as this would damage the
hinges that support it.
WARNING: to prevent boiling, do not use containers filled with liquids or food that liquefies
with heat, in excessive amounts that cannot be easily kept under control. For this reason, only
use trays that let you see inside the container. When extracting a tray containing hot liquid pay
attention not to spill any liquid: BURN HAZARD!
5.2 Installation and connection
The following instructions are aimed at the qualified installer, to ensure that he carries out the
installation, adjustment and maintenance operations as correctly as possible and according to current
legal regulations. Any operation must be performed with electrical power cut to the appliance.
Before using the appliance, carefully remove the special adhesive film protecting the parts in stainless
steel. Do not leave any glue residues on the surfaces. If necessary, remove them at once with an
appropriate solvent.
Fitting the feet - The feet are inside the appliance and must be secured on the four threaded holes on
the base. If necessary, the height of the feet can be adjusted by screwing or unscrewing.
Positioning - Position the appliance perfectly horizontally on a table or similar support (the table or
support must be at least 85 cm above the floor). Position it at a distance of not less than 10 cm from
the side and rear walls, to enable natural ventilating air to circulate freely around it. The device is
aerated by forced ventilation which flows out of the slits on the rear metal panel, assuring efficiency
and long duration.
For this reason it is strictly forbidden to obstruct these ventilation openings, even partially or for short
periods. Failure to observe this specific prohibition releases the manufacturer of the appliance
from all responsibility and immediately voids any guarantee rights for the said appliance,
because its constructive conformity has been voluntarily compromised. Furthermore, the device is
not suitable for built-in installation or to be installed on top of other identical devices.
Electrical connection - The appliance must be connected to the electrical mains according to current
legal regulations. Before making the connection, make sure of the following:

Publicidad

loading