Publicidad
Idiomas disponibles
Idiomas disponibles
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used again.
d)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Make sure that no water enters through the ventilation openings in the casing.
g)
Clean the ventilation openings with a brush and compressed air.
h)
Perform regular inspections of the unit checking technical fitness and any damages.
i)
Do not use sharp and/or metal objects (e.g. a wire brush or metal spatula) as these may
damage the surface of the appliance material.
j)
Do not clean the unit with acidic substances, medical products, diluents, fuel, oil or other
chemicals as this may cause damage to the device.
k)
Regularly lubricate the machine according to the instructions.
Grinding a new matrix
IMPORTANT! The die is a consumable part - its service life is approx. 300 working
hours or 30 days (daily use for approx. 6 hours). The used element is not subject to
warranty. If the wear of one side of the matrix is 4 mm, it should be replaced with a
new one.
Before first use, a new matrix should be polished and cleaned by following the process described
below:
a) Prepare:
5 kg of flour or sawdust
•
5 kg of fine sand (optional)
•
1.5 liters of vegetable oil, used or contaminated
•
EN
Publicidad
