Publicidad
Idiomas disponibles
Idiomas disponibles
B. Cleaning and Disinfection
Before the machine is used for the first time, it should be carefully
disinfected and cleaned. The specific methods are as follows:
Take 5 to 6 liters of warm water, drop in an appropriate amount of food
detergent, and prepare a cleaning and disinfectant solution according to
its instructions. Pour the cleaning solution into each beverage bucket and
let it flow into the refrigeration cylinder. Press the "Clean" button. Run for
about 5 minutes, pull down the handle, discharge the cleaning fluid
through the outlet valve, repeat the above operation, and rinse with clean
water 2 to 3 times.
1. The temperature of the cleaning fluid must not exceed
60°C, otherwise parts may be easily damaged.
2. All water in the cylinder must be drained after cleaning,
otherwise the mixer will be damaged by freezing during
refrigeration.
3. When pressing the "Clean" button, pay attention to the
Notice
indicator light to avoid accidentally pressing the "Auto"
button.
C. Install Feed Tube
Note: Please choose the following appropriate installation method
according to the type of feeding components of the model you purchased.
Feed Tube (I) Installation
a. Place the sealing ring in the groove of the feed joint. Use a small
amount of Vaseline to lubricate it during installation to facilitate installation.
b.Insert the holed end of the feed tube into the feed hole of the mix hopper.
Normally
Use to expand the ice cream; if necessary, the feed tube can be installed
- 9 -
Publicidad
